3 PCS 10 Head Ultrasonic Mist Maker Fogger Mister Air-Cooled Humidifier Fog Machine with Waterproof Power Supply
Free Shipping to USA and Worldwide
1. Strong adaptability to the water quality atomization, also using pure water or tap water can work.
2. Suitable for the power supply of various products to ensure that it can still be used normally in large occasions.
3. Power polarity protection circuit can prevent damage to the product user interface.
There is a start delay circuit to avoid excessive inrush current into the line.
5. The single line sprinkler head adopts independent design and overcurrent protection circuit, which can prevent the sprinkler head from burning out due to power cord damage, and does not affect the normal operation of other sprinkler heads.
6. The current voltage and temperature of the machine has less impact, because each time the current electronic automatic adjustment nozzle, the current increases the temperature will be reduced (does not affect the amount of fog), to avoid the serious heat of the tube current which will increase the vicious cycle and damage to the atomizer.
7. This product adopts high thermal conductivity, high corrosion resistance, good mechanical strength of the metal shell, reducing the temperature difference between the water inside the host, thus extending the service life of the product.
1.Do not place your hand on top of the fog chamber when the nebulizer is working to avoid ultrasonic damage.
2. The nebulizer must be worked in water before using water, then place it inside its own hide and make sure that there is water on the surface of the spray film to avoid damaging the nebulizer.
3. When you stop using the atomizer before disconnecting the power supply, remove it from the sprayer.
When using the atomizer, use an output power of at least 250W and an output voltage of DC45 ± 5V.
When using the same container to build multiple nebulizers, each nebulizer has a separate power supply, you do not need to connect multiple nebulizers to a single power supply to use, and please note that each nebulizer is conductive shell with each other to prevent electrical corrosion work.
6. The fog produced by the atomizer should be forced to discharge using a fan, each group of nebulizers are reserved 350CM2 of flat space, the water temperature is too high, so as not to shorten the life of the nebulizer.
7. The nebulizer is not suitable for the atomization of corrosive liquids, in order to avoid damage to the nebulizer and the atomizing metal plate.
Do not damage the level sensor switch during the installation process, as a malfunction of the switch will cause the water level to rise to prevent the atomizer from going out of control. Stop when the level switch is damaged; otherwise, the dry atomizer will be further damaged. In this case, use the required repair after the repair by qualified service personnel.
Consumption: 5000 ml (clean water required)
Power cord: 1.5m
Atomization Rate:18 kg/h
Water temperature: 5-55°C (normal temperature is 30°C)